🎰 リンクジョーカー - カードファイト!! ヴァンガード Wiki

So, you can detect where on which step the possible problem is on. STEP 4. Thank you very much for your understanding. Be sure to see Configurator found at COM Port message. Please just skip this step. We kindly advise testing with UDP as a first. To be sure that your Driver is updated correctly, you should see STMicroelectronics Com Port as below: If you see Your COM Port It could be different than COM3 as above, please continue with the next steps, otherwise please check your driver and if you have any issue please contact us. As a first step, you should open the enclosure. After that, you can change the data transmission period by yourselves. We also kindly advise you to test your device on the NetOP platform as a First. Name it as you wish. After that, you may test MQTT as well. You will receive an activation e-mail. And then direct your data from their platform, as an example T-Mobile with 1nce NB-IoT Sim card in The Netherlands. You will receive these files via an e-mail. You should see its default settings as below: 4. STEP 6: Activate Power Supply There are 3 different enclosures. By using your WiFi Modem Main page by having a look at IP addresses on your network. STEP 5: Insert NB-IoT Sim Card to the Device Please insert an NB-IoT Sim Card which has NO PIN CODE to the device. This is the NetOP IoT Platform address, if you want to use another Platform, please set its IP address. And then it will be activated. STEP 4: Connect your Bluetooth Gateway to the Internet by using either Your WiFi or GSM Sim Card At this point, it should be better to start with WiFi not to face any issue because of Sim Card. Your device should be plug and play and no need to do any configuration Please update your COM Port Driver by using STM32 drivers. And check it out that the device is on the list. Otherwise, you can set your APN or IP address by yourselves by using standard Micro USB Cable. Below screenshot is an example with Temperature Humidity Sensor, your settings would be different depending on your sensor type. You can find this IP address either 1. If not, you can detect on which step it is stuck.{/INSERTKEYS}{/PARAGRAPH} Your device should be plug and play and no need to do any configuration. Login with your e-mail and password. After that, you should be seeing its WiFi Hotspot by using your PC or Mobile Phone by searching Wireless Networks you can find this on the below step by step video. Click on the device. After updating your Driver, please insert a Micro USB cable to the device and also to your Computer. Thank you! You will receive its data here. To change the settings: 4. {PARAGRAPH}{INSERTKEYS}If it is a smart beacon, please just remove the plastic yellow material. Please install the NetOP Configurator Exe program which works on Windows We will be providing Mac and Linux Versions soon! And insert its antenna. Activate your account by using the link in the e-mail.